Guides
AirSkin touched alert - Roof Only
Follow the flowchart below. For each stage that requires further instructions you’ll find the instructions below: Reset Airskin {ADD IMAGE} Open GUI menu Ope...
Crane is not moving
Follow the flowchart below. For each stage that requires further instructions you’ll find the instructions below: No Reading from Cable Sensor No Readings fr...
Robot not turning on after pressing 'Run Robot'
Follow the flowchart below. For each stage that requires further instructions you’ll find the instructions below: Check communication with Operator Control B...
GUI cameras not showing in the GUI
Follow the flowchart below. For each stage that requires further instructions you’ll find the instructions below: Check communication with Secondary Robot Re...
KUKA Controller not on EXT Mode
Connect smartPAD Rotate the Keyswitch to change operation mode (horizontal) Select EXT Rotate the Keyswitch back to its original position (vertical) Press th...
No Readings from Cable Sensor
When cable sensors reading disappears or is frozen reset crane controller Open GUI menu Go to Services Tab Press Crane Controller Wait for service to fully r...
Robot is not spraying water
Follow the flowchart below. For each stage that requires further instructions you’ll find the instructions below: Check communication with Water Control Box ...
AirSkin touch alert - In front of facade
This is a Safety Procedure. Do not move to next step until the previous step was completed. Press operator E-Stop - Freeze the situation Contact Platform Ope...
Reverse Osmosis (RO) System First Operation
Perform this before operating the system for the first time, after a long time of storage or when there is air inside the RO system Connect the RO system to ...
Robot is not moving - 0.0 reading from cable sensor
If robot is turned on and approaches the facade but does not start cleaning check the following: Is the drop distance equal to 0.00 Do the robots respond to ...